ALL DAY 7AM to 8PM 0426 098 685 Call Now
Tech Tips

Check Engine Light On? What It Means and What to Do Next

Check Engine Light On? What It Means and What to Do Next

The check engine light (sometimes shown as an engine outline, or labelled "service engine soon") comes on when the engine's computer detects a fault it can't correct on its own. It covers hundreds of possible problems, from trivial to serious — so the light itself tells you something is wrong, not what.

Flashing or steady?

  • Flashing: usually means a severe misfire. Unburnt fuel can reach the catalytic converter and overheat it. Slow down, avoid hard acceleration, and have the car checked as soon as possible — ideally without driving it far.
  • Steady: a fault has been logged. The car may feel normal, but it should still be checked soon rather than ignored.

If the light comes on along with a red warning — oil pressure, temperature or brakes — stop somewhere safe and don't keep driving.

Common causes

  • A loose or damaged fuel cap (it can trigger an evaporative-system fault).
  • Faulty oxygen sensors or air-flow sensors.
  • Worn spark plugs or ignition coils causing misfires.
  • Vacuum leaks and cracked intake hoses.
  • Catalytic converter or emissions faults.
  • Diesel-specific problems such as a blocked DPF or EGR faults.

Why a code isn't a diagnosis

A scan tool reads a fault code such as "P0300 — random misfire". That tells you where the computer noticed the problem, not what caused it: a misfire could be a plug, a coil, an injector, a vacuum leak or low compression. Proper diagnosis means reading the codes, looking at live sensor data, and testing the likely parts before replacing anything. Swapping parts based on a code alone often costs more in the end.

Should you clear the light?

Clearing the code without fixing the cause just hides it. The light will come back, and you lose the stored information that helps find the fault. Get it read and diagnosed first.

What to do now

  1. Check the fuel cap is tight — then give it a few drives to see if the light goes out.
  2. Note anything unusual: rough idle, loss of power, smells, noises, or when the light first came on.
  3. Have the codes read and the fault diagnosed.

We carry diagnostic equipment to read and diagnose engine faults where the car is parked, which saves driving a car with a flashing light across town.

Related: DPF warning light on your diesel: what it means.

Need a hand with this? TECH-MECH comes to your home or workplace across Melbourne. Tell us about the car and we'll send a written quote.

Get a free quote
5.0 ★ 💬 Get a Quote