ALL DAY 7AM to 8PM 0426 098 685 Call Now
Tech Tips

Car Overheating: What to Do on the Spot and the Usual Causes

Car Overheating: What to Do on the Spot and the Usual Causes

An overheating engine can turn a repairable problem into a very expensive one if you keep driving. If the temperature gauge climbs towards the red, a warning light comes on, or you see steam from under the bonnet, act straight away.

What to do on the spot

  1. Turn off the air conditioning to take load off the engine.
  2. Turn the heater to hot and the fan to full. It's uncomfortable, but it moves heat out of the engine through the heater core.
  3. Pull over somewhere safe and switch the engine off.
  4. Don't open the radiator or coolant cap while it's hot. The system is under pressure and scalding coolant can spray out. Wait until the engine has cooled — often 30 minutes or more.
  5. Once cool, check the coolant level in the reservoir. If it's low, topping up with the correct coolant (or water, in an emergency) may get you somewhere safe — but the cause still needs finding.

Driving on with an overheating engine risks a blown head gasket or a warped cylinder head.

The usual causes

  • Low coolant from a leak — a split hose, a leaking radiator, a failed water pump seal or a loose clamp. The cooling system is sealed, so coolant going missing means it's escaping somewhere.
  • A stuck thermostat — if it stays closed, coolant can't reach the radiator.
  • Water pump failure — a worn pump stops circulating coolant; look for leaks or a whining noise from the front of the engine.
  • A blocked or damaged radiator — internal corrosion or debris on the fins reduces cooling.
  • Cooling fan faults — if the car overheats in traffic but is fine on the freeway, the electric fan (or its relay or sensor) is a prime suspect.
  • Head gasket failure — signs include white exhaust smoke, coolant loss with no visible leak, bubbles in the coolant, or milky oil.

Preventing it

  • Check the coolant level regularly, with the engine cold.
  • Use the coolant type your manufacturer specifies; mixing types can cause problems.
  • Have the coolant replaced at the interval in your logbook — it loses its protection over time.
  • Get small leaks and damp hoses looked at before summer.

Getting it fixed

Finding a cooling fault usually starts with a pressure test to locate leaks, then checks on the thermostat, fan and water pump. We handle radiator, cooling system and water pump repairs where the car is — useful when the car shouldn't be driven.

Need a hand with this? TECH-MECH comes to your home or workplace across Melbourne. Tell us about the car and we'll send a written quote.

Get a free quote
5.0 ★ 💬 Get a Quote